Comtrol AT Commands for SmartACFL Manuel d'utilisateur télécharger pdf (Page 137)

Command Reference Manual

100722A

Conexant

5-15

5.4.11 +FCIG: - Report the Polled Station ID

Syntax: +FCIG: “< ID string>” Polled Station ID

This response reports the received transmit station ID string, if any. This message is generated in execution of Originate,

Answer, +FDT, or +FDR commands.

5.4.12 +FDTC: - Report the Polled Station Capabilities

Syntax: +FDTC: “< string>” Polled Station Capabilities

If the answerer has a document to poll, it would be communicated to the originator in bit 9 of the DIS frame. The originating

station may elect to transmit a fax, and later, send SIG and DTC frames to pick up the polled document. The answering

station would report the incoming DTC frame via the +FDTC: response message after command mode is canceled with the

AT+FDR command.

5.4.13 +FPOLL - Indicate Polling Request

Syntax: +FPOLL:

This message is sent to the DTE if the received DIS message indicates that the remote station has a document to poll (by bit

9 in the DIS) and polling has been enabled with the AT+FSPL command. The DTE may then decide to receive rather than

transmit.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 171 172

Pas de commentaire

Comtrol AT Commands for SmartACFL Manuel d'utilisateur Page 137