Comtrol RocketPort Serial Hub Series Manuel d'utilisateur télécharger pdf (Page 50)

50 RAS Installation and Configuration

Windows NT

RAS Installation and Configuration

After installing the software, and installing and configuring at least

one RAS device (for example, a modem), use this section to install and

configure Remote Access Service (RAS).

Initial RAS Installation

If you have not previously installed RAS in your Windows NT server,

log into the server with Administrative rights and follow these steps:

Note: This example shows how to install and configure RAS for use

with modems, but you can use it as a guide to setting up other

serial devices.

1. Open the Control Panel and start the Network applet, or right-click

on the Network Neighborhood and select Properties. The following

screen displays:

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 87 88

Pas de commentaire

Comtrol RocketPort Serial Hub Series Manuel d'utilisateur Page 50