Comtrol Multiport Modems Windows NT Manuel d'utilisateur télécharger pdf (Page 29)

Adding or Reconfiguring a RAS Device

The Remote Access Setup

window reappears.

9. Highlight the COM port

(modem) again and select the Network

button.

10. Select the appropriate dial out protocols,

dial in protocols, logon security levels,

enable multilink (if required) and select

the OK button

Note: Only previously configured protocols

are selectable. If you want to set up a

protocol that is grayed out, you must

first add it using the Network

Protocols tab.

If you selected “Receive calls only” on all

ports while configuring the port usage, the

“Dial out Protocols” area will be shaded.

If you want to use Multilink PPP

(bonding), make sure that you select the

Enable Multilink check box.

For detailed information about the

configuration windows, use the Help button or the Windows NT CD-ROM

(Support/books/server.hlp file to locate information).

Note: The following steps are dependent upon the protocol selections made in this

window.

11. If you select NetBEUI on the Network

Configuration window, the following

window appears. Make the appropriate

selection for your environment and select

the OK button.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Pas de commentaire

Comtrol Multiport Modems Windows NT Manuel d'utilisateur Page 29