Comtrol RA Series Manuel d'utilisateur télécharger pdf

Setting the DIP Switch

The following table is provided for you in cases where

you did not receive device driver documentation or for

your reference. The device driver documentation

provides controller installation procedures and advises

you how to set the

DIP switch.

To prepare your controller for installation, you may

need to set the

I/O address DIP switch. The default I/O

address range is 180 through 1C3.

For the first controller, select a 68-byte

I/O address

range. For subsequent controllers, select a 64-byte

range.

RocketPort controllers use

I/O address ranges at 400

hexadecimal (hex) intervals above the I/O range. Most

peripherals use

I/O address ranges between 0 and 3FF

hex. If you have peripherals installed above 400h, you

may experience an

I/O conflict. The first controller

determines the settings for additional controllers.

Installing the Controller

After you set the I/O DIP switch, you are ready to

install the controller. Use the following steps to install

the controller:

1. Turn the power switch for the system unit to the

OFF position.

2. Remove the system unit cover.

3. Select a slot to install the controller.

4. Remove the expansion slot cover.

5. Insert the controller in the expansion slot, make

sure that it is properly seated.

6. Attach the controller to the chassis with the

expansion slot screw.

7. Replace the cover on the system unit.

Controller

#1 I/O

Address

Range

DIP Switch Settings

(Controller #1 determines the other

controller settings.)

100 - 143 hex

140 - 183 hex

180 - 1C3 hex

(Default)

Controller #1 Controller #2

12345678

Controller #3 Controller #4

Controller #1

Controller #2

12345678

Controller #3

Controller #4

12345678

Controller #1

Controller #2

12345678

Controller #3 Controller #4

200 - 243 hex

280 - 2C3 hex

300 - 343 hex

Controller

#1 I/O

Address

Range

DIP Switch Settings

(Controller #1 determines the other

controller settings.)

Controller #1 Controller #2

12345678

Controller #3 Controller #4

Controller #1 Controller #2

12345678

Controller #3 Controller #4

Controller #1 Controller #2

12345678

Controller #3 Controller #4

RocketPort

and RocketPort RA Series

Setting the DIP Switch Reference

1 2

Résumé du contenu

Page 1 - and RocketPort RA Series

Setting the DIP SwitchThe following table is provided for you in cases where you did not receive device driver documentation or for your reference. Th

Page 2 - Contacting Comtrol

If connecting a system with an interface box:a. Attach the male end of the RocketPort or RocketPort RA cable to the controller and the female end to t

Commentaires sur ces manuels

Pas de commentaire

Comtrol RA Series Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires de communication Comtrol RA Series. Comtrol RA Series User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Comtrol RA Series